This article explains how to use WPA-PSK on NETGEAR wireless routers.
WPA-PSK offers better network security than WEP. Newer routers offer even stronger security protocols than WPA-PSK like WPA3 and WPA2. NETGEAR recommends using WPA3 or WPA2 when they are available.
To secure your network using WPA3, see the following article:
How do I enable WPA3 security on my NETGEAR router?
To secure your network using WPA2, see the following article:
How do I change the WiFi password or security level on my NETGEAR router?
Note:
- You can enable only one security protocol (WEP, WPA, etc.) per wireless network at a time.
- You must configure your wireless clients, such as wireless computers, to use the same security protocol as the router or access point.
To enable the WPA-PSK protocol:
- Connect an Ethernet cable from your computer to any LAN port on your NETGEAR router or access point.
- In a web browser, such as Google Chrome or Microsoft Edge, enter the router or access point's IP address in the address bar.
The default IP address is 192.168.0.1 or 192.168.1.1. - Enter the user name and password.
The default user name is admin. The default password is password.
NETGEAR recommends changing the default password to increase the security of your network. - Select Wireless Settings from the left side navigation bar.
- Under Security Options, select WPA-PSK (Wi-Fi Protected Access Pre-Shared Key).
- In Security Encryption (WPA-PSK) > Passphrase, enter a passphrase.
The passphrase must be 8 to 63 characters long.
Note: You must have the passphrase to connect to the wireless network. - Click Apply.
Last Updated:07/07/2025
|
Article ID: 13111