Bug Fixes & Enhancements:
- genie tools can not refresh network topology.
- Default AP IP and gateway are not on same subnet.
- IPv6 Logo.
- CD-less genie-The user information displays on the right of the table with opera.
- Annex B:DSL WAN port can't connect DSLAM when select connection mode: Manually Connect.
- Traffic meter: Round up data volume is still effective in WAN DHCP mode.
- IP assign : VPN policy ip subnet address don't change after LAN ip changed.
- VPN: Wrong character in warning message when add two dynamic remote address policy.
- WPS: The text box on GUI for users to enter client PIN don't accommodate up to 9 characters.
- Traffic meter: The current traffic statistics data are cleared when users do the factory reset.
- WPS: When "Enable SSID Broadcast" is un-checked, there is no a diaglog box comes up with the message to asks for users.
- USB storage: Share page don't display new share folder when HTTP or FTP method access USB storage.
- Router will hangup while doing a full service test.
- Change country code to Q1/27 for FCC and EU/29 for CE.
- Update BSP to 4.12L08, wl driver to 6.30 RC163.23 for support wireless TxBF function.
- WLAN can not join multicast streaming when set WAN as the server.
- After auto detection and setup wizard PPPOE wan success .the display in a different ISPs on the basic setting page.
- New shared folders can be created even user enter one non-exist folder manually.
- Router MAC address issue.
- LAN host run VLC sever. WLAN host will can't connected DUT.LAN host run FTP client ,WLAN host ping package on and off.
- WLAN host can not read/write the content of USB storage via ReadySHARE Remote even have installed "Readyshareremotesetup.exe".
To Install
Note: To avoid wireless disconnect issue during the firmware download process, NETGEAR recommends that firmware upgrade be performed on a computer with wired connection.
- Write down all the settings which you changed from the default values, since you may need to re-enter them manually.
- Download the firmware and save it to a convenient place such as your desktop. Unzip if needed.
- Log in to the router using a Web browser. The URL is http://www.routerlogin.net.
- Click ADVANCED tab > Administration > Firmware Upgrade.
- Click Browse and find the file you just downloaded.
- Click Upload. Do not interrupt the upgrade while the router does this step.
Important Note:
- The upgrade process is completed when the on screen progress bar completes. If power LED light turns amber and blinking, power cycle the router to complete the upgrade.
- If the upgrade progress bar on web GUI doesn’t display correctly during firmware upgrade, you can still check the status using Power LED. The Power LED should be blinking (amber) during firmware upgrade. After firmware upgrade is done and boots up the system, it changes to steady amber color.
Please DO NOT power off or reboot the device during firmware upgrade, otherwise, it may result to a corrupt firmware and cause the device not to work.
Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data throughput rate.
This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page