To configure SNMP:
1. Select System > Settings > Services.
The Services section of the Setting screen displays (the following figure shows the top of the screen only):
2. Click the SNMP button.
The SNMP Settings screen displays:
3. Configure the settings as explained in the following table:
|
Item |
Description |
|
Enable SNMP |
Select the check box to enable SNMP globally; clear the check box to disable SNMP globally. |
|
Community |
Enter the community. Normally, you would enter public for a read-only community and private for a read-write community. You can leave the Community field set to public (which is the default setting), or specify a private name if you have a more segregated monitoring scheme. |
|
Trap destination |
Enter the IP address to which the ReadyDATA sends the traps that it generates. For information about the types of messages that can be sent, see the What are system logs and how do they work with my ReadyDATA storage system? |
|
Hosts allowed access |
Enter a network address that specifies the hosts that are allowed to access the ReadyDATA. |
4. Click Apply.
Note: For information about the NETGEAR SNMP MIB, see the What is SNMP monitoring and how does it work with my ReadyDATA storage system?