Backward compatibility issues:
- The FVS318Gv2 hardware SKU only supports firmware version 4.x.x.x (platform 2.0 base) or greater.
Bug Fixes:
-
,
- When the router static route is private ,it also sends the static route in RIP ,
- Allows to use the bandwidth profile for a schedule based firewall rule ,
- Fixed Device is vulnerable for POODLE SSLv3 vulnerability (CVE-2014-3566) ,
- Fixed Device is vulnerable for CVE-2014-3568 ,
- Unable to access GUI after adding static route with private IP enabled. ,
- IPSec VPN to client: VPN cannot establish when "Remote IP" select "Range". ,
- Start port cannot be equal to End port when define a service ,
- SNMP node "nlogSyslogState" should be editable ,
- No DHCP server log and help page missing ,
- nvpnSSLVPNPolicyClientAddressRangeBegin nvpnSSLVPNPolicyClientAddressRangeEnd should not be allowed to set to 0.0.0.0 and 255.255.255.255 ,
- Can't edit LAN traffic Meter Account
Know Issues and Limitations:
-
,
- Unable to add IP address on the network in source IP address page ,
- Observed inconsistant behaviour with voice traffic when server is lying in LAN and DMZ side ,
- Device showing blank certificate when subject name is having successive comma ,
- For the port speeds 10Base T FULL_Duplex and 100Base T FULL_Duplex, the duplex setting is showing as half ,
- [CLI]Able to add 2 mode config records with same pool start ip and end ip ,
- Device is accepting same Local and Remote LAN IP in manual tunnel. ,
- When "Disable Ping Reply on LAN Ports" is enabled the WAN ip of router is not reachable from the LAN host. ,
- No NAT translation of SIP headers during REGISTER, outbound call and SDP ,
- There is no validation for SIIT Address field. ,
- IPv6 IPSec client tunnel is not getting established in main mode. ,
- Device is not accepting the static route for the network 0.0.0.0 on LAN or VLAN interface. ,
- [IPv6]Unable to run IPERF-UDP and FTP traffic from LAN to WAN on SIIT tunnel. ,
- Stun packets are getting drop in sip module ,
- Device IPv6 WAN is not getting RADvD IP address when Router's MAC Address is configured for "Use this computer's MAC Address" or "Use this MAC Address". ,
- [CLI]There are no proper validations for the domain name in CLI ,
- [CLI]schedules are not getting edited properly from CLI
Installation Instructions:
- Using the Download Link below, download and extract the new firmware to a convenient place such as your desktop.
Download Link: http://www.downloads.netgear.com/files/GDC/FVS318GV2/FVS318Gv2_V4.3.2-7.zip
Note: Reboot the firewall before beginning the update process. - Select Administration > Settings Backup and Firmware Upgrade from the main/submenu.
- In the Router Upgrade section, click Browse.
- Locate the downloaded file and click Upload.
This will start the software upgrade to your VPN firewall. This may take some time. Do not interrupt the upgrade process.
At the conclusion of the upgrade, your firewall will reboot.
Last Updated:10/17/2025
|
Article ID: 26829