Fixed issues
-
,
- Sometimes Auto-VoIP messages of 'send failed' are observed in the syslog. ,
- Some configurations (like STP BPDU forwarding and IPv6 traffic filter) are lost after upgrading from 5.3.0.17 to 5.3.0.25. ,
- Stack could hang after running for some time. ,
- While changing the static route configuration, there is chance that the master unit would reboot with the following message shown in the techsupport log: “hapiL3AsyncTask crashed in GS7xxTPS stack system”. ,
- Changed the default voice and video VLAN ID from 2 and 3 to 4088 and 4089 respectively.
Known issues
-
,
- Port LED is incorrectly lit when 100BaseFX SFP module is inserted to port 25/26 (GS728TS/TPS) or port 49/50 (GS752TS/TPS).
,[Workaround] The 100Base-FX SFP module is not supported on port 25/26 of GS728TS and GS728TPS or port 49/50 of GS752TS and GS752TPS. These ports only support 1Gbps SFPs or 10Gbps SFPs. The 100BaseFX optic can be used on the rest of SFP ports on these platforms.
Notes
-
,
- This smart switch platform supports dual firmware image. Before upgrading the firmware of a stack system, please make sure the ‘Next-active’ field under ‘Maintenance > File Management > Dual Image status’ pages are the same for all the units in a stack. They should be set to ‘image1’ as factory default. ,
- NETGEAR 10G SFP+ AXM761/762/763 can be used for long-distance stacking for GS7xxTS/TPS. However, the stacking bandwidth is still 2.5G per port
Using the Download Link below, download and extract the new firmware to a convenient place such as your desktop.
Download Link: http://www.downloads.netgear.com/files/GDC/GS728TPS/GS728-752_TS_TPS_V5.3.0.26.zip
Last Updated:10/17/2025
|
Article ID: 26717