Note:
It will take about 8 minutes for the first boot up after upgrade to 6.0.1.16 from previous releases 6.0.1.x, because the switch will auto-upgrade the new PoE firmware. Please wait patiently till the switch completely boot up.
GS516TP support the latest Smart Control Center, please use SCC version 1.1.3.2 for switch discovery, basic configuration and FW upgrades.
Fixed Issues
- Only one port works well with the time-range when apply same time-range to several ports.
- Unable to get any value from MIB object table - Dot1dTpFdbTable
- There is delay (3~6 seconds) when powering on PoE via SNMP
- IGMP Snooping querier admin mode is not saved after device reboot
- Cannot set password with special character such as "<", ">", "&", etc.
- Max number of entries in the Buffered logs file is 50 instead of 64
- Enhanced this version by adding additional PoE debug commands
Limitations
- Reboot is required when switching between ‘Switch’ mode and ‘Router’ mode.
- Dynamic VLAN assignment and DiffServ Simple policy (flow based policer) can only be supported in ‘Switch’ mode, but not supported in ‘Router’ mode.
Using the Download Link below, download and extract the new firmware to a convenient place such as your desktop.
Download Link: http://www.downloads.netgear.com/files/GDC/GS516TP/GS516TP_V6.0.1.16.zip
Last Updated:10/17/2025
|
Article ID: 25793