Note: Please remember to do factory default after firmware upgrade if you upgrade this firmware from V1.0.1.14 Enter “Backup Settings” in the web GUI and click “Erase” button of “Revert to factory default settings”.
New Features & Bug Fixes:
- Fixed the security hole issue (CVE-2013-3069, CVE-2013-3073,CVE-2013-3074)
Known Issues:
- NTFS write performance (upload to WNDR3700 attached USB storage) is much slower than read no matter using samba or FTP. FTP read is 5 times faster than write. Samba (ie. access network drive via windows) read is 2 times faster than write.
- Sometimes clicking “Safely remove USB device” button can't remove USB storage safely.
Workaround: Make sure you are not accessing the attached USB device and the LED on USB device is not blinking (it means no one is accessing it). Then you need to remove the USB device directly and ignore the message about “remove USB device failure) from web GUI. - Traffic meter – Traffic volume control is not accurate due to sampling rate. It may exceed the limit.
Workaround: Set a proper number in “Mbytes before the monthly limit is reached” in the traffic control.
To Install:
Note: To avoid wireless disconnect issue during the firmware download process, NETGEAR recommends that firmware upgrade be performed on a computer with wired connection.
- Write down all the settings which you changed from the default values, since you may need to re-enter them manually.
- Using the Download Link below, download and extract the new firmware to a convenient place such as your desktop. The filename after extracting is WNDR3700v2_WNDR37AVv2-V1.0.1.14.img.
Download Link: http://www.downloads.netgear.com/files/GDC/WNDR3700V2/WNDR3700v2_WNDR37AVv2-V1.0.1.14.zip
- Log in to the router using a Web browser. The URL is http://www.routerlogin.net.
- Click ADVANCED tab > Administration > Firmware Upgrade.
- Click Browse and find the file you just downloaded.
- Click Upload. Do not interrupt the upgrade while the router does this step.
Important Note:
- The upgrade process is completed when the on screen progress bar completes. If power LED light turns amber and blinking, power cycle the router to complete the upgrade.
- If the upgrade progress bar on web GUI doesn’t display correctly during firmware upgrade, you can still check the status using Power LED. The Power LED should be blinking (amber) during firmware upgrade. After firmware upgrade is done and boots up the system, it changes to steady amber color.
Please DO NOT power off or reboot the device during firmware upgrade, otherwise, it may result to a corrupt firmware and cause the device not to work.
Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data throughput rate.
This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page