New Features:
- Support Windows 8 32-bit SSL VPN .
Issue(s) are resolved since last Release V3.0.9-02:
- Identifier cannot input 131 characters.
- Cannot Creating firewall rules for TCP Port 113 (ident).
- WAN load balancing mode, WAN1 and WAN2 DynDNS account are updating with WAN1 IP after device reboot.
- After adding the static routing-interface 'dmz', the interface change to 'WAN1' in edit page and cannot edit the routing.
- Firewall rule works abnormally when schedule task which is default configuration and bandwidth profile is called at the same time.
- DDNS status wrong.
- Portal cannot support some special characters.
- VPN wizard online help does not match the function.
- Profile displaying abnormally when edit outbound bandwidth profiles to inbound.
- No ipsec tunnel uptime in online help document.
- Service group name automatically before save, it will generation same service name records.
- Redundance message in ipsec mode config record.
- Remote desktop on a VPN connection (SSL / Ipsec).
- LDAP attributes list.
- Support for IGMP in Load Balancing mode.
- DUT allowing FTP port commands where the IP address in the port command is different than the FTP client IP address.
- Device freeze once or twice a week.
- Using a invalid domain server, ssl vpn should do not login successfully.
- NFS service does not work in firewall rules.
Known Issue(s) and Limitations:
- Issues with respect to voice in load balancing mode, when sip server is present in DMZ zone.
- Inbound voices are not heard between sip clients over vpn tunnel when sip server is lying in the remote private network.
- SIP clients at other end of tunnel are unable to register through VPN tunnel when SIP server is in LAN side of DUT.
- SSL VPN logs page not showing logs when ssl and port forwarding users disconnected.
- Unable to do ftp data tranfer when ssl client is behind nat router in port forwarding tunnel.
- Unable to edit the ipsec vpn user while in use.
- Bandwidth profile is not working over vpn tunnel.
- When a Firewall rule for Address Range is edited and Block always is selected the "WAN Destination IP address" is grayed out.
- IGMP information need to be updated in attack check help page.
- PPTP idle time out is not working when IGMP proxy enabled.
- Inconsistant behavior while establishing calls between LAN and WAN and vice-versa with IGMP Pass through enabled.
Installation Instructions:
- Download the link below and save it to a convenient place such as your desktop.
Note: Reboot the firewall before begining the update process. - Select Administration > Settings Backup and Firmware Upgrade from the main/submenu.
- In the Router Upgrade section, click Browse.
- Locate the downloaded file and click Upload.
This will start the software upgrade to your VPN firewall. This may take some time. Do not interrupt the upgrade process.
At the conclusion of the upgrade, your firewall will reboot.
Last Updated:10/17/2025
|
Article ID: 23145