Bug Fixes
- GUI genie: genie Internet detection shows incorrect username and password in PPPoE mode connection.
- WAN ACCESS -- PPPoA: Wrong status display after setup wizard.
- GUI genie: GUI genie can not detect DHCP WAN mode.
- GUI genie: genie Internet detection shows incorrect username and password in PPPoA mode connection.
- Management: Reset default settings fail.
- IPSEC VPN -- SA Lifetime: Router accepts wrong configuration about sa life time.
- IPSEC VPN -- Manual Policies - SPI: SPI display "A", while configurate it "00A".
- IPSEC VPN -- Range address: Router doesn't accept normal configuration, and gives wrong warning.
- IPSEC VPN Encryption -- DES: Set the policy with encryption of DES, Router can't create VPN tunnel successfully.
- IPSEC VPN DH Group -- Group1: Set the DH group with DH1, Router can't create VPN tunnel successfully.
- IPSEC VPN : Router can't add any new policy after wrong configuration.
- IPSEC VPN -VPN Wizard: first step page should display "step 1 of 4 ", not "step 1 of 3".
- Wireless -Disable router's pin: Router doesn't accept the configuration to enable the function.
- Traffic meter: Traffic Status display no correct in Connection time control.
- Traffic meter: Traffic volume mode:no popup warning message shown, after the alarming line reached.
- Traffic meter: Connection time mode:no popup warning message shown, after the alarming line reached.
- IPv6: setup 6to4 mode as Internet Conection type,Router can not reach IPv6 gateway in WAN side.
- IPv6: setup DHCP mode as Internet Conection type,Router can not reach IPv6 gateway in WAN side.
- IPv6: setup PPPoE mode as Internet Conection type,Router can not reach IPv6 gateway in WAN side.
- IPv6: Auto Detect mode as Internet Conection type,Router can not detect connect type,WAN side support DHCP mode.
To Upgrade
Note: To avoid wireless disconnect issue during the firmware download process, NETGEAR recommends that firmware upgrade be performed on a computer with wired connection.
- Using the Download Link below, download and extract the new firmware to a convenient place such as your desktop.
Download Link: http://www.downloads.netgear.com/files/GDC/DGN2200V3/DGN2200v3-V1.1.00.21_1.00.21NA.zip
- Using a browser, login to the router as admin.
- Under Maintenanceclick Router Upgrade.
- Click Browse and locate the upgrade (.img) firmware image file you just downloaded
- Click Upload. Wait for the upgrade progress bar to complete and final prompt to appear.
This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page
Last Updated:10/17/2025
|
Article ID: 22223