New Features:
- Sierra 305 & 313 dongle models added
The dongles supported the regions were they operate are listed below.Dongle Model Country/ISP Firmware version ZTE MF110 China Unicom BD_UCP671A2V1.0.1B01 ZTE MF190 China Unicom BD_UCMF190V1.0.0B01 HUAWEI E173 Spain Movistar 11.126.15.00.18 HUAWEI E1752 11.126.08.02.18 HUAWEI E1752C 11.126.10.16.18 ZTE MF110 MF110V1.0.0B01 ZTE MF190 MF190V1.0.0B07 HUAWEI E352 France Orange 11.102.19.01.314 11.102.23.04.314 Sierra 305 USA - AT&T I1_0_8_12AP CARMD-EN000104 2009/11/17 22:26:18 Sierra 313 USA - AT&T SWI9200_01.00.03.01.APR2748 CARMD-EN-10526 2011/07/25 19:31:25
Resolved issues:
- 3G reconnection issue in certain poor signal condition.
Known issues:
- SLOT ADSL idle timeout and WAN1 PPPoE/PPTP idle timeout do not work.
- Log query search criteria do not work when an IPSec VPN is established.
- When Disable l2tp pass through is set, the l2tp client can still establish an l2tp tunnel.
- A SSL VPN user cannot login successfully when the domain's Authentication Type is "LDAP" and "LDAP Encryption/Port: SSL/636".
- When you enable inbound Bandwidth Profile, outbound traffic speed is also affected.
- OSX 10.6.6 Java 1.6.0_24 is unable to see connect/disconnect buttons.
- Page Portal URL links show an error when the Portal Layout Name contains special characters.
- Sip client registration fails when the UTM SIP ALG is enabled in router mode.
- If you repeatedly disable and enable traffic metering on WAN1, the traffic volume increases.
- If you change the LAN group name, firewall rules cannot be deleted.
- The LAN WAN outbound rules do not work after you change the NAT IP field.
- The LAN groups page does not show the LAN user configured as the LAN secondary IP address.
- VPN Tunnel creation Virtual Passage Installation fails when using IE9.0 and Firefox5.0.
- When load balancing 3G and WAN, WAN will stop for one or two minutes when the 3G is down.
- Occasionally, all WAN interfaces may not start up.
- UTM9S release version 2.0.16 known issues apply.
- Idle timeout does not work.
- UTM9S hangs with 2000 HTTP connections.
- LAN WAN rules for service "NFS" does not work.
- A client to gateway vpn does not work if One UTM WAN is a private IP.
- A ssl vpn tunnel cannot be up.
- In LB mode, when WAN1 is up and the USB is down, ping baidu is not always successful until the USB is up.
- The GUI displays an error if you use Chrome browser (16.0.912.77 m).
- [Customer issue] DSL does not work properly if the desktop PC is turned off and the ADSL module is disconnected.
- disable "increase this monthly limit " does not take effect on the WAN metering page.
- If you enable alg, the throughput is zero when the cc is 100.
- When IPS or bandwidth control is enabled, Hardware offload is disabled.
- In wan1 only mode, wan1 will disconnect for 1 minute when you select wan2 and click "apply".
- USB does not support advanced page.
- USB will disconnect and then reconnect when USB is the backup in rollover mode.
- If you turn the UTM9S off then on again, you cannot access the admin page.
- Too many logs print out in the console.
- If you use Chrome/Safari, there is a GUI display Mismatch.
- In wan1, wan2, USB WLB mode, the wan2 display continues after unplugging wan2.
- The reset button function does not work normally on the wan metering page.
- The secondary ip l2tp does not work normally.
- The secondary ip pptp does not work normally.
- You cannot always access administrator pages when doing rip testing.
- The reset button does not work properly on the firewall edit page.
- The title display is incomplete in the Chrome browser(16.0.912.77 m).
- wan metering's total traffic sum is wrong if outgoing or incoming traffic is less than 1M.
- In LB mode, if the USB port is unplugged, the wan1 network will disconnect for about 1minute.
- There is a serial output error when you upgrade to v2.1.0-32.
- All interfaces do not come up after 4-5 reboots.
- There is serial output of 3g and pppd info when you reboot the system or unplug/insert a USB device.
- The wait time is too long when the update server is unreachable.
Windows Vista 32 bit systems.
- SSL VPN Tunnel and Port Forwarding cannot connect when using Firefox5.0 on Windows Vista 64 bit systems.
- When you disable a Bandwidth firewall rule, the Bandwidth Profile still works.
- After deleting a customer VLAN you cannot delete static routes.
- You cannot access web sites when Load Balancing Mode and Time Zone "GMT-8" is selected.
- When the WAN Traffic Meter reaches a limited value, the device under test does not block traffic.
- If you add an Outbound policy "LAN Users" and "WAN Users" you cannot use custom IP Groups.
To Install
- Download the file, unzip it and follow the instructions provided in the user manual to upload the firmware.
-
149 MB
This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page
Last Updated:10/17/2025
|
Article ID: 20846