New features:
- IPv6 Firewall support.
- IPv6 Prefix Delegation.
- IPv6 IPSEC and SSL VPN.
- Multiple SSID for wireless.
Bug Fixes:
- Loopback does not work for DMZ LAN.
- When click Auto detect button on wan settings page,lan can not connect internet for more than 7minutes.
- Can't establish tunnel that use Radius-PAP authentication.
- Ping using Diagnostic tool in GUI fails over ipv6 ipsec tunnel.
- Sometimes,sync time need to wait a long time.
- Can't config FQDN in 'Add New VPN Policy' page.
- DMZ WAN also can not connect after added route.
- Can't config IPSec "client to gateway" vpn that use IPv6 address in VPN Wizard page.
- Can not add the customer vlan when whose DHCP server is disabled and can not disable the DHCP server of default vlan.
- Unit shows critical error when capture packets.
- Can not configure LAN DHCP relay.
Known Issues:
- GUI response is slow when the device is under stress.
To Upgrade
IT IS VERY IMPORTANT TO NOT POWER-CYCLE THE UNIT BEFORE THE UPGRADE COMPLETES! IF YOU DO INTERRUPT THE UPGRADE, THE ROUTER WILL BE RENDERED USELESS!
- Select the download appropriate to your region, and download to a convenient place such as your desktop.
27.4 MB - Using a browser, login to the router as admin.
- Under Management, click Router Upgrade.
- Click Browse and locate the upgrade file you just downloaded
- Click Upload. The upgrade process may take up to ten minutes or more; in rare cases it might take even longer.
- Please wait for the yellow TEST LED to turn off before connecting to the GUI again.
- Once the upgrade is complete, the browser may show an error page (404 – Page not found). At this point, please connect to http://192.168.0.1 to access the new GUI.
For problems after upgrading, clear the configuration, using the Factory Defaults pushbutton on the rear panel, or the Erase button in the Backup Settings menu. Then reenter your configuration information manually.
Last Updated:10/17/2025
|
Article ID: 20303