Supported Models:
GS728TS, GS752TS, GS728TPS and GS752TPS
- The GS728TS/GS752TS Smart Switch has 24/48 10/100/1000 Mbps copper ports and 6 SFP fiber ports, 2 of which are combo ports. Up to two SFP ports (the last two ports) at a time can be used as 2.5G stacking ports to create six unit stack system.
- The GS728TS/GS752TS Smart Switch has 24/48 10/100/1000 Mbps PoE capable copper ports and 6 SFP fiber ports, 2 of which are combo ports. Up to two SFP ports (the last two ports) at a time can be used as 2.5G stacking ports to create six unit stack system.
Known issues
- Port is incorrectly up when insert 100BaseFX SFP module to port 25/26 (GS728TS/TPS) or port 49/50 (GS752TS/TPS).
[Workaround] The 100Base-FX SFP module is not supported on port 25/26 of GS728TS and GS728TPS or port 49/50 of GS752TS and GS752TPS. Those ports only support 1Gbps SFPs or 10Gbps SFPs. The 100BaseFX optic can be used on the rest of SFP ports on these platforms.
-
The switch does not prompt error or warning message when try to configure the ports on the stack unit that does not exist.
[Workaround] None.
Notes
This firmware release support dual firmware image. Before upgrade a stack system, please make sure that the 'Next-active' field under 'Maintenance->File Management->Dual Image status' pages are the same. They should be set to 'image1' as factory default.
Installation Procedure
GS7xxTS/TPS supports the latest Smart Control Center, please use SCC version 1.1.3.1 for switch discovery, basic configuration and FW upgrades.
Size: 9.04 MB