Bug Fixes:
- Under Switching > Multicast > Static Multicast Address > Multicast Group Membership, can’t successfully change Interface Status from Excluded to Static or Forbidden.
- Password with 4 or more repeating characters seems to be accepted when changing the default password. However, the switch will reject the login with this new password.
- Unable to import private key successfully for SSL certificate under Security > Access > HTTPS > Certificate Management page
Known Issues:
- The local device UI displays the incorrect number of configured IPv6 routes.
- Multicast forwarding entries are not cleared immediately after the port is shut down.
- When using an AGM734 SFP transceiver on port 10 to connect to a peer that is powered off, the link flaps every 60 seconds.
- When configuring management VLAN other than VLAN 1, the default static IP (192.168.0.239) becomes 0.0.0.0.
Workaround: Use DHCP, or assign a valid static IP address. - If updating firmware through a USB device, the USB device must support the FAT32 file type. The NTFS file type is NOT supported.
- On high speed ports 7 to 10 (5G or 10G), the minimal interface shaping rate is 3.6 Mbps.
- Cable testing when performed on ports 5 to 9 (multi-Gigabit ports):
- Cable status might display “Open at 140 meter” instead of a “good cable” when there is no cable, or when the cable is shorter than 1 meter in length.
- Cable length might display “Length > 140 Meters” for cables shorter than 5 meters.
Download Link : https://www.downloads.netgear.com/files/GDC/MS510TX/MS510TX_TXPP_V6.7.0.52.zip
Firmware Update Instructions:
To update your product’s firmware, follow the instructions in your product’s user manual. To find your user manual, visit https://www.netgear.com/support/, enter your model number in the search box, and click the Documentation button on the product page.
Last Updated:07/07/2025
|
Article ID: 000064831