Some NETGEAR Smart Switches now offer a command line interface (CLI) in addition to the local browser user interface (UI). The NETGEAR Smart Switch CLI does not support all of the configuration options that are available in the local browser UI, so we are calling it a lite CLI.
You can connect to your smart switch's lite CLI using your preferred Secure Shell (SSH) client.
To access your smart switch's lite CLI, you must meet the following requirements:
- Your switch model is listed under "This article applies to" on this knowledge article.
- You know the switch's IP address and administrator password.
- Your switch is running a firmware version that supports the lite CLI.
Switch Model Number Minimum Required Firmware Version GS728TPv2 6.0.10.5 GS728TPPv2 6.0.10.5 GS752TPv2 6.0.10.5 GS752TPP 6.0.10.5 GS308T 1.0.5.5 GS310TP 1.0.5.5 GS108Tv3 7.0.9.5 GS110TPv3 7.0.9.5 GS724TPv2 2.0.8.5 GS724TPP 2.0.8.5 MS510TXM 1.0.5.5 MS510TXUP 1.0.5.5
Your NETGEAR Smart Switch's lite CLI supports the following categories of commands:
- System commands:
- Management
- Power over Ethernet (PoE)
- Link Layer Discovery Protocol (LLDP)
- Switching commands:
- Interface
- Link aggregation group (LAG)
- Virtual local area network (VLAN)
- Auto-Voice over Internet Protocol (Auto-VoIP)
- Spanning Tree Protocol (STP)
- Media Access Control (MAC) address table
- Routing commands:
- IP routing
- Routing table
- Address Resolution Protocol (ARP)
- Security commands:
- Management security
- Access
- Traffic control
- Monitoring commands:
- Port
- Logging
- Mirroring
- Maintenance commands:
- Reset
- Copy
- File management
- Ping
Last Updated:07/07/2025
|
Article ID: 000064429