New Features and Enhancements:
- To comply with new California privacy law, remove ‘None’ option from authentication protocol for SNMPv3 (System > SNMP > SNMPv3 > User Configuration). Default is now ‘MD5’.
Bug Fixes:
- When link speed of port 1 is 10Mbps or 100Mbps, port 5 cannot link at 2.5Gbps.
- Fails to provide IEEE 802.3at PoE power to Ruckus Access Point - R750.
Known Issues:
- The local browser UI displays the incorrect number of configured IPv6 routes.
- Multicast forwarding entries are not cleared immediately after the port is shut down.
- Link flaps every 60 seconds with port 10 if using an AGM734 SFP transceiver to connect a peer that is powered off.
- When configuring management VLAN other than VLAN 1, default static IP (192.168.0.239) becomes 0.0.0.0.
Workaround: Use DHCP or assign a valid static IP address. - If updating firmware through a USB device, the USB device must support the FAT32 file type. The NTFS file type is NOT supported.
- On high speed ports 7 to 10 (5G or 10G), the minimal interface shaping rate is 3.6 Mbps.
- Cable testing when performed on ports 5 to 9 (multi-Gigabit ports):
- Cable status might display “Open at 140 meter” instead of a “good cable” when there is no cable or for cables shorter than 1 meter.
- Cable Length might display “Length > 140 Meters” for cables shorter than 5 meters.
Download Link : https://www.downloads.netgear.com/files/GDC/MS510TX/MS510TX_TXPP_V6.7.0.50.zip
Firmware Update Instructions:
To update your product’s firmware, follow the instructions in your product’s user manual. To find your user manual, visit https://www.netgear.com/support/, enter your model number in the search box, and click the Documentation button on the product page.
Last Updated:10/17/2025
|
Article ID: 000062488