Bug Fixes:
- Switches in a stack setup randomly reboot 1 to 2 times per month.
- Link on the switch is down when the speed is changed from 1G to 100MB on the remote device.
- Change default QoS trust mode from dot1p to ip-dscp (from 'classofservice trust dot1p' to 'classofservice trust ip-dscp'): When customer does image upgrade to 12.0.9.4 or later releases, default/explicitly configured QoS dot1p (in the old image) will be changed to ip-dscp. If customer wants dot1p QoS mode, then customer has to explicitly configure dot1p again after the image upgrade.
- Switch is not accessible if the user stays in “change default password page” on the GUI for a minute and then closes the page.
- LLDP remote device information wasn't flushed when the port is disconnected.
Known Issues:
- When a 40G port on APM402XL is expanded into 4 10G ports, these 10G ports cannot be configured as stacking port due to hardware limitation
- The 40G port can be expanded into four 10G ports via new ‘hardware profile portmode’ command, but this command will not retain across stack failover from stack master to standby unit.
- User could pre-configure a APM402XL before the module is inserted the slot. And most of port configuration can be applied except the port expander command, ‘hardware profile portmode’ will fail.
- The port LED on APM402XL module is not blinking when there is line activity and the 40G port is operating in four 10G ports mode. (HW limit)
- Stacking port mode does not survive hot plug-out and plug-in. One or more ports of an APM can be configured in Stacking mode. Once reloaded with this APM inserted, those ports would still operate in stacking mode. However, during run time, if the same APM is plugged out and plugged back in, the configured stack ports will be restored back to Ethernet mode. User would need to reconfigure them manually for stacking mode after hot insertion.
- Hot plug-in of any APM module won’t work if M4300-96X is booted without any APM pre-installed and with factory default settings. Install at least one APM module before booting up the switch.
- When APM402XL is operating in four 10G port mode, and connects these 10G ports are connected with a DAC fan-out cable, the link #1 of DAC fan-out cable will show up as port 3 in switch’s configuration and physical link #3 will show up as port 1 inside the switch’s configuration. This will be fixed in the upcoming maintenance release.
- M4300-96X copper port doesn’t link up at 2.5Gbps when it is connected to WAC740’s 2.5G port, it works only at 1Gbps. This will be fixed in the upcoming maintenance release.
Firmware Update Instructions:
To update your product’s firmware, follow the instructions in your product’s user manual. To find your user manual, visit https://www.netgear.com/support/, enter your model number in the search box, and click the Documentation button on the product page.
Download Link: http://www.downloads.netgear.com/files/GDC/M4300/GSM_XSM4300_V12.0.9.4.zip
Last Updated:07/07/2025
|
Article ID: 000061592