The MS510TX/MS510TXPP provides 4 multi-Gigabit Ethernet and 4 1G Ethernet RJ-45 copper ports with one dedicated 10G RJ-45 copper uplink port and one dedicated SFP+ fiber uplink port that supports 10G and 1G.
- Two of the four multispeed ports support 5G, 2.5G, and 1G.
- The other two multispeed ports support 2.5G and 1G.
- The 10G RJ-45 copper uplink port also supports 5G, 2.5G and 1G.
Model MS510TXPP supports Power over Ethernet plus (PoE+) on all four multispeed ports and four 1G ports. It can supply up to 30W PoE+ (IEEE 802.3at) to each port, with a maximum PoE power budget of 180W across all active PoE+ ports.
MS510TX/MS510TXPP supports the latest Smart Control Center, please use SCC version 1.1.3.4 for switch discovery, basic configuration and FW upgrades.
This release notes contains known issues and notes for firmware 6.7.0.27.
Download Link : http://www.downloads.netgear.com/files/GDC/MS510TX/MS510TX_TXPP_V6.7.0.27.zip
Known issues:
- Switch’s DHCPv6 client can't get IPv6 address for management after enable IPv6 routing.
[Workaround]: Using static IPv6 address from management.
- Dynamic LAG status is showing up even when LACP protocol is not up and running with peer device.
[Workaround]: Enable LACP on peer device.
- Multicast forward entries would not flush immediately when port is shut down.
[Workaround]: Wait for the entries to age out when expired.
- Voice VLAN remarking CoS still work when disabled the remarking.
[Workaround]: Configure the expected CoS value to lower the impact.
- Linkup port flaps every 60 seconds when port 10 connected a shutdown peer devices with AGM734.
[Workaround]: Get the port link up on peer device; or link down the connection by removing the cable.
- SCC can't backup configurations for multiple devices at the same time.
[Workaround]: Backup the configurations for one device each time.
Notes and Limitations:
- On high speed ports 7~10 (5G or 10G), minimal interface shaping rate is 3.6Mbps.
- The USB device must support the FAT32 file type. The NTFS file type is NOT supported.
- Cable testing when performed on ports 5~9 (multi-Gigabit ports):
- Cable status may show Open at 140 meter instead of good cable, if there is no cable or cables up to 1 Meter.
- Cable Length in some cases may show “Length > 140 Meters” for cables shorter than 5 meters.