Use SNMP management systems such as HP OpenView or CA UniCenter for remote monitoring of the ReadyNAS. (Management over SNMP is not supported.)
To configure SNMP:
1. Select System > Settings > Services.
2. Click the SNMP button.
The SNMP Settings screen displays.
3. Configure the settings as explained in the following table:
|
Item |
Description |
|
Enable SNMP |
Select the check box to enable SNMP globally. Clear the check box to disable SNMP globally. |
|
Community |
Enter the community. Normally, you would enter public for a read-only community and private for a read/write community. You can leave the Community field set to public (which is the default setting) or you can specify a private name if you have a more segregated monitoring scheme. |
|
Trap Destination |
Enter the IP address to which the ReadyNAS sends the traps that it generates. |
|
Hosts Allowed Access |
Enter a network address that specifies the hosts that are allowed to access the ReadyNAS. |
4. Click the Apply button.
Your changes are saved.
This article applies to the following ReadyNAS and EDA storage system models:
-
ReadyNAS 102
-
ReadyNAS 104
-
ReadyNAS 312
-
ReadyNAS 314
-
ReadyNAS 316
-
ReadyNAS 516
-
ReadyNAS 2120
-
ReadyNAS 3220
-
ReadyNAS 4220
-
EDA 500